Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-19
Locate the New Slot
5. Verify that the FESA ADAPTER object is in the STOPPED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $adapter-name
Example 4-25 shows the output of this command. Note that the ADAPTER
(E0153) is in the STOPPED state.
Locate the New Slot
Find the group, module, and slot containing the FESA you want to move and the empty
slot to which you want it moved. The empty slot contains a double-high filler panel.
(Figure 4-2 on page 4-20 shows the FESA slot locations.)
Remove the double-high filler panel from the slot to which you want to move the FESA.
Set the filler panel aside. You will reinstall the filler panel in the slot left vacant by the
FESA you move.
Label the Communications Cables Connected to the FESA
To label the communication cable for an FESA:
1. Find the group, module, and slot in which the Fast Ethernet ServerNet adapter
(FESA) is installed.
Figure 4-2 on page 4-20 shows the FESA slot locations.
Example 4-25. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153 STOPPED