Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-26
Remove and Install the Adapter
9. Press the blue-green tab on the FESA ejector and latch the ejector to seat the
FESA against the backplane.
10. Disconnect the grounding clip of your ESD wriststrap from the enclosure.
11. Install the double-high filler panel in the slot left vacant by the FESA you moved.
12. Connect the RJ-45 connector to the Ethernet port on the FESA. Connect the other
end of the cable to your Ethernet hub. Use the label on the cable to make sure you
connect the cable to the proper port and Ethernet hub.
Figure 4-8 on page 4-27 shows the connection of the communication cable
between the FESA and vendor Ethernet hub.
Figure 4-7. Installing an FESA
058CDT .CDD