Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-28
Check the Installation of the FESA
Check the Installation of the FESA
To check the installation of an FESA:
1. Make sure that the power-on LED (green light) is on.
Figure 4-9 on page 4-29 shows the location of the power-on LED and fault LED.
2. If the power-on LED does not come on, do one or both of the following:
•
Reseat the FESA.
•
Check the FESA and backplane connector for damaged pins.
Note the Following Error Conditions
•
If the power-on LED does not come on after you reseat the FESA, you must
replace the FESA
•
If the FESA or backplane connector have damaged pins, both the FESA and
backplane (or enclosure) must be replaced. For backplane replacement
instructions, refer to the HP NonStop S-Series Service Provider Supplement.
Note. When the adapter is inserted, the fault LED (amber) remains on until the service
processor has completed its start-up configuration. The fault LED also comes on when
SLSA detects a POST failure.