Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-30
Resume Operations
Resume Operations
The following describes starting the relocated FESA.
Complete the Configuration Form
Complete a new configuration form for the relocated FESA. Figure 4-10 on page 4-32
shows an example of a completed Fast Ethernet ServerNet Adapter (FESA)
Configuration Form.
Identify the following information for the relocated FESA:
•
The name you want to use to identify the adapter; for example, E0153 for an Fast
Ethernet ServerNet adapter in slot 53 of the first system enclosure.
•
The location of the adapter within the system cabinet (group, module, and slot).
•
The processors that have access to the SAC on the adapter.
Before you begin the hardware installation, complete an FESA configuration form.
Obtain the form from Appendix A, FESA Configuration Form, and complete the
form as follows:
•
Enter the name of the system in the System Name field.
•
Enter the group number for this enclosure in the Group Number field.
•
Enter the slot number of this FESA in the Slot Number field. FESAs can be
installed in slots 51, 52, 53 and 54 of and I/O enclosure (expansion) but only
53 and 54 of a processor enclosure. Figure 4-2 on page 4-20 shows the
possible slot locations for the FESA.
•
Because there is exactly one module in a system enclosure, the module
number, 1, is already indicated on the form.
•
Complete the Ethernet Port information block.
•
Enter the IP or network address to be assigned to the port in the IP
Address field.
•
Enter the adapter name. (See the Manufacturing Naming Conventions on
page 1-9.)
•
Enter the SAC name.
Table 4-3. Resuming Operations Checklist
Step Description
1.
Complete the Configuration Form
2.
Add the FESA Using SCF