Fast Ethernet Adapter Installation and Support Guide

Fast Ethernet Adapter Installation and Support Guide—425685-003
xi
About This Guide
This guide provides step-by-step procedures for adding, removing, replacing, and
moving Fast Ethernet ServerNet adapters (FESAs). This guide is intended for anyone
who installs or maintains FESAs on HP NonStop S-series servers.
Who Should Use This Guide
This guide is intended for anyone who installs or maintains FESAs on NonStop
S-series servers. This guide assumes you have experience in the following:
•
Tandem Service Management (TSM) Service Application
•
ServerNet LAN Systems Access (SLSA)
What’s in This Guide
Table i shows how this guide is organized.
Note. This guide describes using TSM to perform FESA procedures. As of G06.22 and
later RVUs, the HP NonStop Open System Management (OSM) Interface replaces TSM
as the system management tool of choice for NonStop S-series servers and is required to
support new functionality in G06.22 and later RVUs. OSM provides the same functionality
as TSM while overcoming limitations of TSM. For instructions on using OSM or migrating
to OSM, refer to the OSM documentation for your RVU.
Table i. Guide Organization
Name of Section Description
Section 1, Introduction to the Fast
Ethernet ServerNet Adapter (FESA)
Describes the FESA and its relationship to
the SLSA subsystem.
Section 2, Installing a New FESA
Describes how to initially add an FESA.
Section 3, Replacing an FESA
Describes how to remove and replace an
FESA.
Section 4, Relocating an FESA
Describes how to relocate an FESA.
Appendix A, FESA Configuration Form
Provides a blank form for recording the
FESA configuration data.
Appendix B, Preparing an FESA for PMF
or IOMF CRU Replacement
Describes checking the fault tolerance of an
FESA
Glossary
Defines the terms used in this guide.