Fast Ethernet Adapter Installation and Support Guide

Installing a New FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
2-9
Unpack and Install the New FESA
6. Disconnect the grounding clip of your ESD wriststrap from the FESA and connect it
to an exposed, unpainted, metal surface on the service side of the system
enclosure, such as the ventilation holes on the processor multifunction (PMF) or
I/O multifunction (IOMF) CRU. See Figure 2-5, Grounding Clip, on page 2-10 or
Figure 2-4, ESD Protected Environment.
Figure 2-4. ESD Protected Environment
693CDT .CDD
ESD antistatic table mat.
Mat should be connected to a soft
ground
(1 megohm min. to 10 megohm max.)
System Enclosure (Appearance
Side)
ESD wriststrap clipped to
door latch stud (or to any
exposed, unpainted, metal
surface on the enclosure
frame.)
ESD wriststrap
with clip
ESD floor mats
Clip 15 inch straight
ground cord to•screw screw
on grounded outlet
cover.