Fast Ethernet Adapter Installation and Support Guide

Installing a New FESA

Fast Ethernet Adapter Installation and Support Guide—425685-003

2-14

Check the Installation of the New FESA

To check the installation of an FESA:

1. Make sure that the power-on LED (green light) is on.

Figure 2-9 on page 2-15 shows the location of the power-on LED and fault LED.

2. If the power-on LED does not come on, do one or both of the following:

•

Reseat the FESA.

•

Check the FESA and backplane connector for damaged pins.

Note the Following Error Conditions

•

If the power-on LED does not come on after you reseat the FESA, you must

replace the FESA.

•

If the FESA or backplane connector has damaged pins, both the FESA and

backplane (or enclosure) must be replaced. For backplane replacement

instructions, refer to the HP NonStop S-Series Service Provider Supplement.

Note. When the adapter is inserted, the fault LED (amber) remains on until the service

processor has completed its start-up configuration. The fault LED also comes on when

SLSA detects a POST failure.