Fast Ethernet Adapter Installation and Support Guide

Installing a New FESA

Fast Ethernet Adapter Installation and Support Guide—425685-003

2-16

Add and Start the FESA Using SCF

Using the completed FESA configuration form as a guide, use the SCF interface to the

SLSA subsystem to add and start the newly installed FESA.

Adding and Starting the FESA

The following steps outline adding and starting the FESA.

1. Add the FESA by using the SLSA subsystem SCF ADD ADAPTER command as

follows:.

SCF adds an FESA to slot 53, group 1, module 1, and gives processor 0 primary

access to the ServerNet addressable controller (SAC). Processors 1 through 3 are

assigned secondary access.

2. Use the SLSA subsystem SCF NAMES command to display the names assigned

to the SAC and PIF of the adapter you added in Step 1.

3. Assign logical interface (LIF) to the PIF on the FESA added in Step 1 by using the

SLSA subsystem SCF ADD LIF command. Use the name of the PIF returned from

the NAMES command in Step 2.

4. Start the LIF by using the SLSA subsystem START LIF command.

5. Start the FESA and its subordinate SAC and PIF objects by using the SLSA

subsystem SCF START ADAPTER command with the SUB ALL option as shown

in the following example. The SUB ALL option starts the ADAPTER object and its

subordinate objects:

Note. Refer to the LAN Configuration and Management Manual for detailed information on the

SLSA subsystem SCF commands.

->ASSUME PROCESS $ZZLAN

->ADD ADAPTER $ZZLAN.E1053, TYPE FESA, LOCATION (1,1,53),

ACCESSLIST (0,1,2,3)

->NAMES PIF $ZZLAN.E0153*

SLSA Names PIF \SYS.$ZZLAN.E0153

PIF

$ZZLAN.E0153.0.A

->ADD LIF $ZZLAN.L018, PIF E0153

.0.A

->START LIF $ZZLAN.L018

->START ADAPTER $ZZLAN.E1053, SUB ALL