Fast Ethernet Adapter Installation and Support Guide

Replacing an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
3-17
Abort the FESA
Abort the FESA
To abort an FESA, perform the following:
1. Stop access to the logical interface (LIF) associated with the Fast Ethernet
ServerNet adapter (FESA) to be replaced.
Use the SCF ABORT LIF command for each LIF:
ABORT LIF $ZZLAN.lif-name
2. Verify that the LIF associated with the FESA to be replaced is in the STOPPED
state.
Use the SCF STATUS LIF command:
STATUS LIF $ZZLAN.*
Example 3-23
shows the output of this command. Note that the logical
interface (LIF) is in the STOPPED state.
Example 3-22. SCF INFO ADAPTER Command
-> INFO ADAPTER $ZZLAN.E0153
SLSA Info ADAPTER
Name Group Module Slot Type
$ZZLAN.E0153 1 1 53 FESA
Note. If Fast Ethernet ServerNet adapters (FESA) are named using the HP Manufacturing
naming convention, you can easily identify the physical location of the FESA by its name as
follows:
$ZZLAN.Ecabid-slot
where cabid is the two-digit number that identifies the enclosure and slot is the actual
physical slot number in the enclosure. For example, the FESA named E0153 is located in
enclosure 01, slot 53. (See Manufacturing Naming Conventions
on page 1-9.)
Example 3-23. SCF STATUS LIF Command
->STATUS LIF $ZZLAN.*
SLSA Status LIF
Name State Access State
$ZZLAN.L018 STOPPED UP