Fast Ethernet Adapter Installation and Support Guide

Replacing an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
3-18
Label the Communications Cables Connected to the
FESA
3. Abort the FESA object and its subordinate objects. You can use either SCF or the
TSM Service Application to perform this step.
a. Using SCF to Abort the Adapter:
Use the SCF ABORT ADAPTER command with the SUB ALL option The SUB
ALL option aborts the ADAPTER object and all its subordinate objects.
ABORT ADAPTER $adapter-name, SUB ALL
b. Using the TSM Service Application to Abort the Adapter:
1. Log on to the TSM Service Application.
2. In the Tree view, select the FESA.
3. From the Display menu, choose Actions.
4. Select Abort.
5. Click Perform action.
4. Verify that the FESA ADAPTER object is in the STOPPED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $adapter-name
Example 3-24 shows the output of this command. Note that the ADAPTER
(E0153) is in the STOPPED state.
Label the Communications Cables Connected to the FESA
To label the communication cable for an FESA:
1. Find the group, module, and slot in which the Fast Ethernet ServerNet adapter
(FESA) is installed.
Figure 3-2 on page 3-19 shows the FESA slot locations.
Example 3-24. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153 STOPPED