Fast Ethernet Adapter Installation and Support Guide

Replacing an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
3-31
Start the New FESA
Verify that Objects Are in the STARTED State
Use the following SCF STATUS commands:
1. Verify that the FESA ADAPTER object is in the STARTED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $ZZLAN.adapter-name.*
Example 3-25 shows the output of the SCF STATUS ADAPTER command.
Note that the ADAPTER is in the STARTED state.
2. Verify that the ServerNet addressable controller (SAC) is in the STARTED state.
Use the SCF STATUS SAC command:
STATUS SAC $ZZLAN.adapter-name.*
Example 3-26 shows the output of the SCF STATUS SAC command. Note that
the ServerNet addressable controller (SAC) is in the STARTED state.
3. Verify that the physical interface (PIF) is in the STARTED state.
Use the SCF STATUS PIF command:
STATUS PIF $ZZLAN.adapter-name.*
Example 3-27 shows the output of the SCF STATUS PIF command. Note that
the physical interface (PIF) is in the STARTED state.
Example 3-25. SCF STATUS ADAPTER command
->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153.0 STARTED
Example 3-26. SCF STATUS SAC command
->STATUS SAC $ZZLAN.E0153.*
SLSA Status SAC
Name Owner State
$ZZLAN.E0153.0 0 STARTED
Example 3-27. SCF STATUS PIF command
->STATUS PIF $ZZLAN.E0153.*
SLSA Status PIF
Name State
$ZZLAN.E0153.0.A STARTED