Fast Ethernet Adapter Installation and Support Guide

Replacing an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
3-33
Restart the Communications Lines
3. From the Resource type pull-down menu, select resource type.
4. From the Display pull-down menu, select Down-rev only.
A list of resources whose firmware is older than the version of the SYSnn is
displayed in the Available list box. Do the following:
5. Double-click on the resource. The resource is displayed in the Selected list
box.
6. Click Perform action to initiate the firmware update.
Restart the Communications Lines
Start the communications lines and SWAN concentrator using the FESA:
1. Start the TCP/IP subnet.
Use the SCF START SUBNET command:
START SUBNET $tcpip-process-name.#subnet-name
2. Start an IPXPROTO process.
Use the SCF START PROCESS command:
START PROCESS $process-name
3. Start a Port Access Method (PAM) line.
Use the SCF START LINE command with the SUB ALL option. The SUB ALL
option starts the LINE object and its subordinate objects.
START LINE $line-name, SUB ALL
4. Start an Expand-over-IP line.
a. Start the WAN subsystem input/output process (IOP).
Use the SCF START DEVICE command:
START DEVICE $ZZWAN.#device-name
b. Start the line(s).
1. Use the SCF START LINE command to start a single line:
START LINE $line-name
2. Use the SCF START PATH command to start all the lines in an Expand
multiline path:
START PATH $line-name
Note. To start a TCP/IP subnet that is configured using Parallel Library TCP/IP, refer to the
TCP/IP (Parallel Library) Configuration and Management Manual. To start a TCP/IP subnet
that is configured using NonStop TCP/IPv6, refer to the TCP/IPv6 Configuration and
Management Manual.