Fast Ethernet Adapter Installation and Support Guide

Replacing an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
3-35
Verify that the Communications Lines are Restarted
2. Verify that the IPXPROTO process is started.
Use the SCF STATUS PROCESS command.
STATUS PROCESS $line-name
Example 3-30 shows the output of this command. Note that the IPXPROTO
process ($ZNV2) is in the STARTED state.
3. Verify that a Port Access Method (PAM) line is started.
Use the SCF STATUS LINE command:
STATUS LINE $line-name
Example 3-31 shows the output of this command. Note that the Port Access
Method (PAM) line ($TOK1) is in the STARTED state.
4. Verify that an Expand-over-IP line is started:
a. Verify that the WAN subsystem IOP is in the STARTED state.
Use the SCF STATUS DEVICE command:
STATUS DEVICE $ZZWAN.#device-name
b. Verify that the line is in the STARTED state.
1. Use the SCF STATUS LINE command for a single line:
STATUS LINE $line-name
Example 3-32 on page 3-36 shows the output of this command. Note that
the line is in the STARTED state.
Example 3-30. SCF STATUS PROCESS Command
->STATUS PROCESS $ZNV2
IPXSPX Status PROCESS
Process Name State Diagnostic State Trace
$ZNV2 STARTED NORMAL OFF
Example 3-31. SCF STATUS LINE Command
->STATUS LINE $TOK1
Primary Backup
Name State CPU PIN CPU PIN Trace
$TOK1 STARTED 1 278 -1 -1 OFF