Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-7
Identify Any Communications Lines and ServerNet
Wide Area Network (SWAN) Using the FESA
4. Determine the PAM line associated with the LIF on the FESA to be replaced.
a. Use the SCF INFO LINE command for the PAM line you identified in Step 3:
INFO LINE $line-name
b. Scan the output for a LIF on the FESA to be replaced. On the FESA Planning
Worksheet, record the PAM line associated with the LIF on the FESA.
Example 4-4 shows the output of this command. The LIF name is shown in the
LIF NAME column. The type of CRU is shown in the LIF TYPE column. Fast
Ethernet ServerNet adapter (FESA) CRUs have the LIF type ENET. In this
example, the FESA CRU LIF named L018 is associated with the PAM line
named $TOK1.
5. Identify the IPXPROTO processes configured on the system.
Use the SCF NAMES SUBSYS command:
NAMES SUBSYS $ZMGR
Example 4-5 on page 4-8 shows the output of this command. IPXPROTO
process names are shown under the PROCESS heading. The two configured
IPXPROTO processes are named $ZNV0 and $ZNV1.
Example 4-3. SCF NAMES Command
->NAMES $ZZPAM
PAM Names \SAMCAT.$ZZPAM
PROCESS
$TOK1 $ZZPAM
LINE
$TOK1
PORT
$TOK1.#L1P0002 $TOK1.#L1P0004
MSAP
$TOK1.#SNATR
Example 4-4. SCF INFO LINE Command
->SCF INFO LINE $TOK1
PAM Info LINE
Name MAXREQUESTSIZE LIF NAME LIF TYPE LIF MAC ADDRESS
$TOK1 3200 L018 ENET 08:00:8E:00:D1:96