FastSort Manual

FastSort Error Messages
FastSort Manual—429834-003
B-18
Numeric List of Programmatic Messages
information about buffers and nowait I/O, see the description of the SORTBUILDPARM
Procedure on page 5-2.
Cause. The block buffer length specified in the call to SORTBUILDPARM was outside
the limits.
Recovery. Correct the value of the buffer-length parameter. For the description of
buffer-length, see SORTBUILDPARM Procedure on page 5-2.
Cause. The distributor-collector process could not start a subsort process in the
processor (CPU) you specified or in any processor in the pool.
Recovery. If you specified a processor, try specifying a different one or letting
FastSort select the processor. Follow recovery recommendations in the Guardian
Procedure Errors and Messages Manual for the operating system error code returned
with this FastSort error code.
Cause. The call to SORTMERGESTART did not specify a valid name for the scratch
file of a subsort process.
Recovery. Specify a valid name in the scratch-file-name parameter. For the
description of scratch-file-name, see SORTMERGESTART Procedure on
page 5-19.
Cause. The distributor-collector process could not communicate with a subsort
process.
Recovery. Follow recovery recommendations in the Guardian Procedure Errors and
Messages Manual for the operating system error code returned with this FastSort error
code.
Cause. The call to SORTMERGESEND or to SORTMERGERECEIVE specified both
a buffer and an extended buffer.
Recovery. Omit either the buffer parameter or the buffer-ext parameter. For the
descriptions of these parameters, see SORTMERGESEND Procedure
on page 5-15 or
SORTMERGERECEIVE Procedure
on page 5-13.
75 INVALID BLOCK LENGTH SPECIFIED.
76 START OF SUBSORT PROCESS HAS FAILED.
77 INVALID NAME OF THE SUBSORT SCRATCH FILE.
78 COMMUNICATIONS WITH SUBSORT PROCESS HAVE FAILED.
79 PARAMETERS ARE MUTUALLY EXCLUSIVE.
80 THE PRODUCT IS NOT INSTALLED.