Fibre Channel ServerNet Adapter Installation and Support Guide (G06.24+, H06.03+)

Safety and Compliance
Fibre Channel ServerNet Adapter Installation and Support Guide—528254-010
Statements-6
Important Safety Information
Important Safety Information
Safety information for dual-threaded hardware manuals is located in two places.
HP NonStop NS-Series Servers
Safety information can be accessed from the left navigation area of the NTL home
page: select NonStop Computing>Important Safety Information. A document
window containing a binder of safety information, in several languages, appears. In
the document window, click a document title to open the safety information in
another language. Local HP support can also help direct you to your safety
information.
HP NonStop S-Series Servers
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and
servicing of equipment described in this manual.
•
Keep door closed for normal operation.
•
The equipment must be installed near the receptacles for the power cords, and the
receptacles must be easily accessible to the user.
Applicability of Procedures, Instructions, and Examples
WARNING. Do not touch the DC power connector on the S7400/S7x000 PMF CRU after you
have unplugged the DC power cable from the CRU. It is possible to incur a severe energy
hazard for as long as fifteen (15) seconds after unplugging the cable. You can make sure the
CRU is safe to remove by testing (by using a volt meter) before touching the pins on the DC
power connector.
WARNING. The procedures and instructions and the examples of procedures and instructions
found in this manual apply only to the system enclosures and components found in Himalaya
S-series servers which are described in the Himalaya S-series server documentation. Do not
attempt to use these instructions with any other Tandem NonStop system equipment. You can
determine that your system is a Himalaya S-series server by reading the label that appears
inside each system enclosure on the CRU in slot 50 or 55. The label includes the product
number 1980. Read the label before proceeding with any procedure or instruction found in this
manual.