Fibre Channel ServerNet Adapter Installation and Support Guide (G06.24+, H06.03+)

Installing an FCSA
Fibre Channel ServerNet Adapter Installation and Support Guide—528254-010
2-12
Install the FCSA
5. Press down and back on the latch; the latch slides under the top lip of the frame
and secures the adapter in place. The ejector latch clicks when the adapter is fully
seated.
6. Disconnect the grounding clip of your ESD wrist strap from the rack or enclosure.
7. Connect the Fibre Channel cables to the Fibre Channel ports on the FCSA by
lining up the retaining clips with the ports and gently inserting them into the ports,
one at a time.
Figure 2-2. Inserting the FCSA Into the Enclosure
Caution. Only handle the Fibre Channel cables in the plastic-protected area at the tip,
preferably at the clip itself. It is easy to break the glass inside the wire either by squeezing the
wire or by bending it too much.
VST011.vsd