Fibre Channel ServerNet Adapter Installation and Support Guide (G06.24+, H06.03+)

Installing an FCSA
Fibre Channel ServerNet Adapter Installation and Support Guide—528254-010
2-20
Connect External Paths
1. Have the FCSA connected to the FC switch or ESS (depending on whether you
are using direct connect or the switched connect).
2. Update the WWN zoning in the SAN so the ESS recognizes the FCSA.
3. Add WWNs to the ESS host group configurations as appropriate.
4. Start the disk again (you can expect it to start this time)
Caution. Do not connect the Fibre Channel cables to the FC switch or the ESS yourself. The
ESS or FC switch administrator must perform this task.
Note. Adding or updating WWNs in the ESS is not required if the FCSA ports are directly
connected to the ESS FC ports.
Note. You may need to reset the disk before the subsystem accepts the START
command.