Fibre Channel ServerNet Adapter Installation and Support Guide (G06.27+, H06.03+)

Fibre Channel ServerNet Adapter Installation and Support Guide—528254-011
ix
About This Manual
This guide describes how to install, replace, and relocate a Fibre Channel ServerNet
adapter (FCSA) in an I/O Adapter Module (IOAM) enclosure.
Who Should Use This Guide
This guide is written for HP service representatives who install or maintain FCSAs in
an IOAM enclosure. The user of this guide should have knowledge of:
•
The OSM Service Connection, part of the HP NonStop Open System Management
(OSM) Interface. For more information about the OSM Service Connection, see the
OSM User’s Guide or the online help within the OSM Service Connection.
•
SCF for the storage subsystem.
What’s in This Guide
Where to Get More Information
Manuals describing the IOAM enclosure in relation to HP NonStop S-series servers are
organized into several sets of manuals, which are fully described in the NonStop S-
Series Planning and Configuration Guide.
Manuals describing the IOAM enclosure in relation to HP Integrity NonStop NS-Series
servers are organized into several sets of manual, which are fully described in the
NonStop NS-Series Planning Guide. For information about how to install disk drive
enclosures containing M8xxx fibre channel disks, see the NonStop NS-Series
Hardware Installation Manual.
Table i. Summary of Contents
Section Title This section. . .
1
Introduction to the FCSA Describes the FCSA and its naming
conventions
2
Installing an FCSA Describes how to install a FCSA
3
Replacing an FCSA Describes how to remove and replace a FCSA
4
Relocating an FCSA Describes how to remove and relocate a FCSA
A
FCSA Configuration Forms for
ESS Connections
Provides a blank configuration form for
recording FCSA configuration information
Glossary
Glossary Describes the technical terms and abbreviations
used in this guide