Fibre Channel ServerNet Adapter Installation and Support Guide (G06.27+, H06.03+)
Fibre Channel ServerNet Adapter Installation and Support Guide—528254-011
1-1
1 Introduction to the FCSA
This section provides an introduction to the Fibre Channel ServerNet adapter (FCSA) 
for I/O Adapter Module (IOAM) enclosures.
Overview of the FCSA 
The M8840 FCSA provides fibre-channel connectivity between: 
•
A NonStop S-Series system and an Enterprise Storage System (ESS)
•
An Integrity NonStop S-Series system and a disk drive enclosure containing M8xxx 
fibre channel disks.
•
An Integrity NonStop NS-Series system and a disk drive enclosure containing 
M8xxx fibre channel disks.
•
An Integrity NonStop NS-series system and an ESS
•
An Integrity NonStop NS-series system and a M8201 Fibre Channel to SSCI 
router, a device that allows connection to N1525A tape drives.
When you connect a NonStop system to an ESS, the FCSA, allows you to connect 
either directly (direct connect) or through a storage area network (SAN) (switched 
connect). (In this manual SAN refers to a storage area network and ServerNet SAN 
refers to a ServerNet system area network.)
The FCSA has two ports that allow connection to external, fibre-channel-enabled 
devices. Figure 1-1 shows the ports on the FCSA.
Overview of the FCSA Page 1-1
FCSA System Connections Page 1-10
Firmware Page 1-10
Manufacturing Naming Conventions Page 1-12
Relationship to the Enterprise Storage System (ESS) Page 1-13
Relationship to the Disk Drive Enclosure Page 1-16
Relationship to Modular Tape Page 1-18
Note. In this manual, the term port refers to the physical connector on the adapter to which 
the cable is connected and is used for hardware discussions such as adapter location and 
connectors. The term ServerNet addressable controller (SAC) refers to the software 
presentation of the port (the I/O controller) and is used when discussing configuration.
Caution. Do not use the Ethernet ports on the FCSA. The Ethernet ports are not compatible 
with the FCSA fibre-channel ports. Port 1 and Port 2 in 
Figure 1-1 are available on an FCSA.










