Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.06+, J06.03+)

Figure 1-2 Power-Status and Fault-Indicator LEDs
The FCSA power-status and fault-indicator LEDs are controlled by the internal hardware and
indicate the adapter states described in Table 1-2.
Table 1-2 Power-Status and Fault-Indicator LEDs
DescriptionStateLED
Adapter is faulty or has been powered
off.
Not litGreen
Adapter is powered.Lit
After installing the FCSA, the green
power-status LED should come on
within a minute.
18 Introduction to the FCSA