Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.06+, J06.03+)

Figure 2-1 ESD-Protected Environment
Check That the Slot Was Not Previously Configured
1. To check that the slot was not previously configured for another adapter, issue these SCF
commands:
-> INFO ADAPTER $ZZSTO.*
-> INFO ADAPTER $ZZLAN.*
2. If the display shows that the slot you want to use is configured for another adapter, delete
that adapter before attempting to install the FCSA.
Ensure the IOAM Is Powered On
Check that IOAM power cables are plugged in and the lights are on. If there is any problem, see
the SCF Reference Manual for the Storage Subsystem.
Install the FCSA
Installation Checklist
1. “Unpack and Inspect the FCSA ” (page 36)
2. “Install the FCSA” (page 36)
Install the FCSA 35