Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.06+, J06.03+)

NOTE: The FCSA weighs approximately 7.25 pounds (3 kilograms).
3. Disconnect the grounding clip of your ESD wrist strap from the FCSA and connect it to an
unpainted metal surface on the IOAM enclosure or on the rack in which the enclosure is
installed.
4. Using both hands, hold the FCSA so that its ejector latch is at the top and its faceplate is
facing toward you. Insert the adapter into its slot in the enclosure. Push the FCSA to the rear
of its slot, but do not force it.
CAUTION: To avoid damaging the connector pins, apply equal pressure to both the top
and bottom of the FCSA when pushing it into its slot. If you try to push the FCSA into its
slot when the pins in either the FCSA or the midplane are damaged, you must replace both
the FCSA and the enclosure.
Figure 2-2 Inserting the FCSA Into the Enclosure
Install the FCSA 37