Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.06+, J06.03+)

NOTE: The FCSA weighs approximately 7.25 pounds (3 kilograms)
Figure 3-4 Removing the FCSA
Download the Firmware
To download the application firmware, complete the tasks listed in Disk Configuration (ESS
Connection) on page 2-14.
Verify the Installation of the FCSA
To verify the installation, follow the procedure described in Verify the Installation of the FCSA
on page 2-13.
Update the Firmware
You can use both OSM and SCF to update the firmware.
On Integrity NonStop NS-series servers, you can update Flashboot Firmware and Flash Firmware.
On NonStop S-series servers, you can update Flash Boot Firmware only. Flash Firmware is not
used on the FCSA when it interfaces to NonStop S-series servers.
Update the Firmware Checklist
1. “Download Firmware for One FCSA”
2. “Download Firmware for Multiple FCSAs”
Download Firmware for One FCSA
To download the firmware by using OSM:
58 Replacing an FCSA