Fibre Channel ServerNet Adapter Installation and Support Guide (G06.28+, H06.06+, J06.03+)

“HIGH LEAKAGE CURRENT, EARTH CONNECTION ESSENTIAL BEFORE CONNECTING
SUPPLY”
“HOHER ABLEITSTROM. VOR INBETRIEBNAHME UNBEDINGT ERDUNGSVERBINDUNG
HERSTELLEN”
“COURANT DE FUITE E’LEVE’. RACCORDEMENT A LA TERRE INDISPENSABLE AVANT
LE RACCORDEMENT AU RESEAU”
FUSE REPLACEMENT
CAUTION – For continued protection against risk of fire, replace fuses only with fuses of the
same type and the same rating. Disconnect power before changing fuses.
Waste Electrical and Electronic Equipment (WEEE)
Information about the Waste Electrical and Electronic Equipment (WEEE) directive is available
from the NonStop Technical Library (NTL) home page. Select Safety and Compliance > Waste
Electrical and Electronic Equipment (WEEE).
Important Safety Information
Safety information is located in two places.
HP NonStop NS-Series Servers
Safety information is available from the NTL home page. Select Safety and Compliance >
Important Safety Information. To open the safety information in a language other than English,
select the language. Local HP support can also help direct you to your safety information.
HP NonStop S-Series Servers
Customer Installation and Servicing of Equipment
The following statements pertain to safety issues regarding customer installation and servicing
of equipment described in this manual.
• Keep door closed for normal operation.
• The equipment must be installed near the receptacles for the power cords, and the receptacles
must be easily accessible to the user.
WARNING! Do not touch the DC power connector on the S7400/S7x000 PMF CRU after you
have unplugged the DC power cable from the CRU. It is possible to incur a severe energy hazard
for as long as fifteen (15) seconds after unplugging the cable. You can make sure the CRU is safe
to remove by testing (by using a volt meter) before touching the pins on the DC power connector.
Applicability of Procedures, Instructions, and Examples
WARNING! The procedures and instructions and the examples of procedures and instructions
found in this manual apply only to the system enclosures and components found in Himalaya
S-series servers which are described in the Himalaya S-series server documentation. Do not
attempt to use these instructions with any other Tandem NonStop system equipment. You can
determine that your system is a Himalaya S-series server by reading the label that appears inside
each system enclosure on the CRU in slot 50 or 55. The label includes the product number 1980.
Read the label before proceeding with any procedure or instruction found in this manual.
82 Safety and Compliance