File Utility Program (FUP) Management Programming Manual

FUP Error Messages
File Utility Program (FUP) Management Programming Manual—523322-001
B-82
86: ZFUP-ERR-NOT-ON-OPTICAL
86: ZFUP-ERR-NOT-ON-OPTICAL
An application specified an optical-disk file in a FUP command (such as LOAD or
CHECKSUM) that does not support optical disks.
Tokens
ZSPI-TKN-ERROR
is the standard SPI error token, which consists of the FUP subsystem ID and the
error number ZFUP-ERR-NOT-ON-OPTICAL (86). This token is always in the error
list.
ZFUP-MAP-CMD-ERROR
is a structured token with these fields:
ZNAME
is the file FUP was processing.
ZCOMMAND
is the FUP command number that caused the error.
ZOBJECT
is the object type.
Recommended Action
The command terminates. If you intended to specify another file that is not on an
optical disk, correct the file specification and retry the command.
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZFUP-MAP-CMD-ERROR
ZNAME type ZSPI-DDL-FNAME.
ZCOMMAND type ZSPI-DDL-INT.
ZOBJECT type ZSPI-DDL-INT.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.