File Utility Program (FUP) Management Programming Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

Introduction

File Utility Program (FUP) Management Programming Manual—523322-001

1-7

FUP Command and Procedure Differences

Table 1-1 shows the interactive FUP commands that you can execute with FUP or

ORSERV programmatic commands. This table also provides the NonStop Kernel file-

system procedure for executing the commands (if applicable) and distinguishes

between the C-series and D-series file-system procedures. Programmatic commands

were developed for most of the FUP functions that did not have a file-system

procedure.

Note. Both C-series and D-series file-system procedure calls are supported on G-series

systems.

Table 1-1. FUP Commands and File-System Procedures for C-Series and D-

Series File Systems (page 1 of 5)

FUP

Interactive

Command

Programmatic

Command

C-Series

File-System

Procedure

D-Series File-

System

Procedure Description

ZFUP-CMD-

GET

VERSION

Returns the FUP

version and the server

ID string

Returns the ORSERV

server version and the

server ID string

ALLOCATE CONTROL CONTROL Preallocates disk file

extents

ALTER ALTER FILE_

ALTERLIST_

Changes the file code,

alternate-key

specifications, and

partition specifications

of a disk file

Also changes the

RESETBROKEN,

REFRESH, AUDIT,

and ODDUNSTR

attributes of a disk file