File Utility Programming (FUP) Reference Manual

File Utility Program (FUP) Reference Manual—523323-015
ix
What’s New in This Manual
Manual Information
File Utility Program (FUP) Reference Manual
Abstract
This manual describes the command syntax and error messages for the File Utility
Program (FUP).
Product Version
T6553 D45, G08, H01, and H02.
Supported Release Version Updates (RVUs)
This publication supports J06.14 and all subsequent J-series RVUs, H06.25 and all
subsequent H-series RVUs, G06.23 and all subsequent G-series RVUs, and D46.00
and all subsequent D-series RVUs, until otherwise indicated by its replacement
publications.To use increased Enscribe limits, the minimum RVUs are H06.28 and
J06.17 with specific SPRs. For a list of the required SPRs, see SPR Requirements for
Increased Enscribe Limits for the H06.28/J06.17 Release.
Document History
New and Changed Information
Changes to the 523323-015 manual:

Updated the attribute START file-id on page 14.

Updated the table File Format Codes on page 1-23.

Added a new section Inserting Partitions in Enscribe Key-Sequenced File on
page 24.
Part Number Published
523323-015 April 2014
Part Number Product Version Published
523323-009 FUP D45, G08, and H01 July 2006
523323-010 FUP D45, G08, and H01 November 2006
523323-012 FUP D45, G08, and H01 October 2009
523323-013 FUP D45, G08, and H01 February 2011
523323-014 FUP D45, G08, and H01 August 2012
523323-015 T6553 D45, G08, H01, and H02 April 2014