File Utility Programming (FUP) Reference Manual

FUP Commands
File Utility Program (FUP) Reference Manual—523323-015
2-195
SHOW
OUT listfile
names an existing disk file or a device to receive the listing output from the SHOW
command. You can use either a standard file name or a spool DEFINE name as
the OUT listfile for a SHOW command. If listfile is an existing file, FUP
appends the output to the file.
create-spec
specifies which file attributes you want to show. If you do not specify any attributes,
FUP shows all the current settings applicable to the current file type.
AS COMMANDS
causes FUP to insert the word CONFIGURE in front of the CONFIG[URE] options. If
this option is present, it can only occur immediately after the CONFIG[URE]
keyword, and you must specify both words. If this display is written to a file, you
can use it to reestablish CONFIG[URE] options from a command file or FUPCSTM
file.
config-simple-opts
config-simple-option [ , config-simple-option ]
config-simple-option is:
ALLOW
DISPLAYBITS
DISPLAYALLNUM
ECHO [CONFIG[URE] | OBEY
IOTIMEOUT
NETBLOCKSIZE
PROMPT [ PURGE ]
REPORTWIDTH
RESTARTUPDATE
STATONLY
XLATE [ xlate-table-name ]
XLATEIN [ xlate-table-name ]
XLATEOUT [ xlate-table-name ]
COPY [ copy-option ]
DUP[LICATE] [ dup-option ]
LOAD [ load-option ]
LOADALTFILE [ loadaltfile-option ]
RELOAD [ reload-option ]
Note. For more information about listfile, see Specifying Files on page 1-8.
Note. For
create-spec parameter default values, see SET on page 2-177. For
config-simple-opts, see CONFIG[URE]
on page 2-28.