Flow Map Manual

Installing Flow Map on the Host
Installing and Running Flow Map
2–2 098935 Tandem Computers Incorporated
Installing Flow Map on
the Host
This subsection describes how to install Flow Map Host (FMH). FMH requires the
Tandem NonStop system release C30 or D20 and the Measure and TPDC software
products.
Installation Procedures The INSTALL program transfers a release of Flow Map Host from tape to an
Installation Subvolume (ISV). Generally, a system manager installs FMH at your site
by using the INSTALL program documented in the System Generation Manual.
Install FMH software files from the Site Update Tape (SUT). The INSTALL program
restores FMH files from the SUT onto the Distribution Subvolume (DSV) and then
copies them to the ISV during the installation process.
You do not need to perform a SYSGEN to install FMH because FMH does not bind any
files in the operating system.
Installation Subvolume When you restore FMH files from the SUT, the following files are located in the ISV
(ZFMH):
File name Description
A0CINFO Configuration files
CONFIG Template configuration file
FLOWMAP FMH program
Sample FMH Installation This sample assumes that you are logged on as SUPER.OPER.
1. Restore the files to the DSV.
2. Run the REPSUBSYS phase of INSTALL.
Running Flow Map
Host
Enter the following to run the Flow Map Host component:
[RUN] FLOWMAP [/OUT log /][ tpdc [,[ cfg ][,[ csv ][,[ print ]]]]]
log
is a spooler location to hold progress messages. The default is the home terminal.
tpdc
is the file name of the TPDC consolidated data file. There is no default and the file
must exist.
cfg
is the file name of the Flow Map configuration. The default file name is CONFIG.
A configuration file must be provided.