G06.24 Software Installation and Upgrade Guide

Resuming Normal Operations
G06.24 Software Installation and Upgrade Guide—528593-005
12-12
Configure Specific Products (Post-System Load)
For example:
> scf
SCF - T9082G02 - (14JAN02) (03JAN02) - 04/28/2003 10:54:23 System
\TEENY
Copyright Compaq Computer Corporation 1986 - 2002
(Invoking \TEENY.$SYSTEM.STARTUP.SCFCSTM)
1-> reset disk $system
2-> start disk $system
STORAGE W01001 To START the disk, SCF must revive the information on
\TEENY.$SYSTEM. This operation might IMPACT system
performance, especially users of $SYSTEM.
Do you want to start a disk revive on \TEENY.$SYSTEM (Y/[N])y
3-> status disk $system
STORAGE - Status DISK \TEENY.$SYSTEM
LDev Primary Backup Mirror MirrorBackup Primary
Backup
PID PID
6 *STARTED STARTED *STARTING STARTING 0,257 1,257
4-> status disk $system
STORAGE - Status DISK \TEENY.$SYSTEM
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
6 *STARTED STARTED *STARTED STARTED 0,257 1,257
SCF automatically revives the unchanged mirror disk, updating the old disk bootstrap
program from the new version copied earlier to the primary disk.
Configure Specific Products (Post-System
Load)
This subsection contains information about the configuration of various products such
as Expand, OSS, and SMF. See product-specific documentation for more information.
Configure Expand and New Profiles
Expand had significant changes starting in the G06.20 RVU (SPR T9057 AFK) that
were also released in SPR T9057AFL as a time-critical fix. The details of many of the
changes and all defect repair changes are described in the T9057G06^AFQ or later
softdoc.
Note. The SCF RESET DISK command does not touch paths that are in a STARTED state.
You could also issue a RESET DISK command for the $SYSTEM-M path and the
$SYSTEM-MB path.
Note. Always check Scout for NonStop Servers for the most up-to-date SPRs for Expand.
Also, review all softdocs for up-to-date installation instructions for the profiles.