G06.24 Software Installation and Upgrade Guide

Overview of Installing G06.24
G06.24 Software Installation and Upgrade Guide—528593-005
1-40
Visual Inspect (G06.20)
Post installation instructions can be found in the appropriate PVU softdoc. New EMS
templates are required for the T8666D35 PVU.
See support note S02075B for details concerning TNOS and data alignment problems.
Visual Inspect (G06.20)
G06.20 includes the Inspect subsystem (T9226G06) and the Visual Inspect server
(T9756AAH) that support PIC programs and DLLs. This version of the server requires
version 2.4 of the Visual Inspect client (T7877AAD).
If you run client product version 2.3 with a G06.20 or later RVU, the client is connected
automatically to the previous version of the server (T9756AAG), and you will not be
able to debug or analyze snapshot dumps from a PIC process.
Unfortunately, client product version 2.4 is incompatible with earlier versions of the
server. Therefore, it can be difficult to debug from the same workstation on multiple
systems, where some systems run G06.20 or later RVUs and some run earlier RVUs.
There are two ways to approach this problem:
•
Install the newer server on the older NonStop systems, along with a compatible
version of the Inspect subsystem. You can install Visual Inspect server SPR
T9756AAH and Inspect subsystem SPR T9226AAK on an HP NonStop K-series
server running the D45.00 or later RVU, or on a NonStop S-series server running
G05.00 through G06.19 RVUs. See the T9756AAH softdoc.
•
Install both Visual Inspect client product versions 2.3 and 2.4 on the workstation.
However, you cannot run both at the same time, and version 2.3 can encounter
problems after 2.4 has run.
WAN Wizard Pro (G06.21, G06.22, G06.23, G06.24)
The NonStop System Console Installer CD (S7X-SWV1, Update 3) includes the WAN
Wizard Pro client version 4.00. This client version is compatible with G06.21 and later
SUTs only. If you have to fall back to a pre-G06.21 RVU, you must de-install the
previous WAN Wizard Pro and re-install the previous WAN Wizard Pro on your system
console. See the WAN Wizard Pro Support Note S04064 for details.
Note. Note that the Visual Inspect client is an independent product and must be ordered
separately. HP strongly recommends that you upgrade both the client and server products
at the same time.
See all related softdocs for installation and configuration information.