G06.25 Software Installation and Upgrade Guide

Contents

G06.25 Software Installation and Upgrade Guide—529430-001

A. Using DSM/SCM to Install SPRs (continued)

Halt the Processors A-9

Perform a System Load A-10

Reload the Processors (If Necessary) A-11

Start Your Applications and Processes A-11

B. Installing the Latest DSM/SCM SPRs and Client Software

Before You Begin Installing DSM/SCM and Client SPRs B-1

Before You Begin Installing the Software Identification (SWID) SPR B-4

Alerts B-4

Determine the Product Version of DSM/SCM on the Host System B-5

Determine the Product Version of DSM/SCM on the Client B-6

Copy (RESTORE) the D46 DSM/SCM Product Version and SWID (Optional) to

Disk B-7

Receive the D46 SPRs for DSM/SCM B-7

Create a New Software Revision for DSM/SCM D46 SPR and SWID B-11

Build and Apply the DSM/SCM D46 Software Revision B-12

Rename the Applied DSM/SCM D46 Files B-14

Run the INSTALL^TEMPLATES Macro B-15

Restart Applications B-15

Before Starting DSM/SCM B-15

Start DSM/SCM B-16

Verify That the D46 Product Version of DSM/SCM Is Installed B-16

Verify That SWID Is Installed B-17

Recovery for Problems While Installing the D46 Version of DSM/SCM B-18

If NonStop Errors Are Displayed B-18

Install the DSM/SCM Client From ZDSMSCM

B-18

Alert (DSM/SCM T6031D46^ABK Client)

B-19

Determine Your DSM/SCM Client Software Version B-19

Determine the Current IP Address and Port Number B-19

Copy the ZDSMSCM Client File From the Host B-20

Install the DSM/SCM Client Software B-21

Create an Emergency Repair Disk (ERD) B-25

C. Updating SWAN Concentrator CLIP Firmware

Using the SWAN Fast Firmware Update Guided Procedure C-2

If the SWAN Fast Firmware Update Fails C-7

Using the TSM Firmware Update Dialog Box to Update SWAN Firmware C-8

Alert C-8