G06.25 Software Installation and Upgrade Guide

Overview of Installing G06.25
G06.25 Software Installation and Upgrade Guide—529430-001
1-4
HP NonStop Server Software Requirements
•
Install the latest D46 product version of DSM/SCM on your host system before you
install the SUT. Appendix B, Installing the Latest DSM/SCM SPRs and Client
Software describes how to restore from tape and install the recommended D46
SPR of DSM/SCM. The D46 DSM/SCM client and server version enable you to
manage OSS files.
°
If you are upgrading to the G06.25 RVU, download the most current client
version of DSM/SCM (T6031D46) from the ZDSMSCM subvolume after the
D46 new product version has been restored and activated from the SUT tape.
The DSM/SCM T6031D46^ABK client software supports T6031D46^ABK
server software and T6030/T6031D30^AAO and previous DSM/SCM server
software (including T6031D31). To install the DSM/SCM client, see
Appendix B, Installing the Latest DSM/SCM SPRs and Client Software.
°
Even if you installed the D46 product version update (PVU) introduced in
G06.18, you must install the new D46 T6031^ABK SPR introduced in G06.25.
See Appendix B, Installing the Latest DSM/SCM SPRs and Client Software. If
you have to fall back to a previous RVU and a pre-T6031D46^ABK product
version of DSM/SCM, you must run the T6031D46^ABK FALLBACK macro.
You can export the FALLBACK macro from the DSM/SCM Archive.
•
Install the Software Identification (SWID) product (T9298D40^AAL) before
receiving the SUT if you are on a pre-G06.20 RVU. See Appendix B, Installing the
Latest DSM/SCM SPRs and Client Software.
Note. All OSS SUT-based products with pax files must have the A7CINFO file in their distributed
subvolumes (DSVs) to be installed by DSM/SCM. Check the appropriate product softdocs and the
Interactive Upgrade Guide to ensure DSM/SCM installation is possible.
OSS products that are not released with an A7CINFO file in their DSVs can still be installed using
PINSTALL /COPYOSS. See the appropriate OSS manuals.
To ensure that OSS-managed files can be correctly restored in case of a fall back to an earlier RVU,
do not use the PINSTALL /COPYOSS utilities to install those OSS products that DSM/SCM has
installed on an OSS file system.
During the Build/Apply phase to manage OSS files, DSM/SCM indicates which OSS products in a
configuration are not DSM/SCM-enabled. For those OSS products, use PINSTALL/COPYOSS.