G06.25 Software Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client

Software

G06.25 Software Installation and Upgrade Guide—529430-001

B-15

Run the INSTALL^TEMPLATES Macro

EMS templates are used by EMS to format EMS messages. After running ZPHIRNM,

and if notified to do so by DSM/SCM, run the INSTALL^TEMPLATES TACL macro to

install DSM/SCM EMS templates in their proper locations.

The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume

and invokes the TEMPLI program to build new resident and nonresident EMS template

files.

You must be logged on as a super.super (255, 255) user to run the

INSTALL^TEMPLATES macro. This macro cannot be run with the NOWAIT option and

takes approximately ten minutes to finish.

For detailed instructions on running the INSTALL^TEMPLATES macro, including

troubleshooting information, see If Running INSTALL^TEMPLATES Is Required on

page A-7.

Restart Applications

You can now start your application software. Follow your site’s procedures for

executing the system configuration and startup (command) files to accomplish this.

DSM/SCM is often started automatically by a system command file; if not, you must

start it manually as described next.

Before Starting DSM/SCM

Depending on your RVU, DSM/SCM will not work properly if SQLCI2 has changed and

DSM/SCM is still using the old version.

1. Check that TMF is started:

> TMFCOM STATUS TMF

2. Verify your current configuration against the cold start configuration in PATHHOST

(or PATHTARG) to check that the current configuration reflects all changes you

have made.

3. Run the PATHCOLD macro from the ZDSMSCM subvolume to cold start the

Pathway configuration.

Note. The files newres and newnres are used as temporary names until the next SYSGEN

and system load.