G06.25 Software Installation and Upgrade Guide

ManualsBrandsHP ManualsServerHP NonStop G-Series

Overview of Installing G06.25

G06.25 Software Installation and Upgrade Guide—529430-001

1-15

Installing a New RVU

Table 1-6 maps the major tasks involved in installing a new RVU to the tools with which

you perform the tasks and the sections in which these tasks are documented.

Note. A checklist is provided in Section 2, G06.25 Upgrade Checklists that summarizes the

tasks required to upgrade to G06.25.

Table 1-6. Tasks and Tools for Installing the G06.25 RVU (page 1 of 2)

To Perform This Task... Use This Tool... Documented in...

1. Install a D46 product version

of DSM/SCM and

fallback/interoperability

SPRs. HP recommends that

you install the D46 SPR on

the host and on the client.

You must also install the

SWID product

T9298D40^AAL if you are

running an RVU before

G06.20.

DSM/SCM Planner

Interface

Section 3, Installing SPRs

Before Upgrading to the

G06.25 RVU

Appendix B, Installing the

Latest DSM/SCM SPRs

and Client Software

2. Save the current

configuration file

(CONFxxyy).

Subsystem Control

Facility (SCF)

Section 4, Preparing to

Upgrade the Server

Software

3. Upgrade the system console

to TSM client software

Version 2004A (if necessary)

or upgrade the OSM

client-component software

NonStop System Console

Installer

NonStop System Console

Installer Guide

System Console

Requirements on page 1-1.

4. Receive new G06.25

software into the DSM/SCM

Archive.

DSM/SCM Planner

Interface

Section 5, Installing the

G06.25 RVU

5. (Optional) Install and

configure the latest TSM or

OSM server SPRs. You must

install the G06.24 or later

client and server SPRs if

using the online boot code

option in OSM or TSM.

DSM/SCM Planner

Interface

See the OSM Migration

Guide or the TSM softdocs.

Section 3, Installing SPRs

Before Upgrading to the

G06.25 RVU