G06.25 Software Installation and Upgrade Guide

Overview of Installing G06.25
G06.25 Software Installation and Upgrade Guide—529430-001
1-16
Installing a New RVU
8. Replace disk bootstrap
microcode (if migrating from
an RVU prior to G06.06).
Subsystem Control
Facility (SCF)
Section 6, Replacing the
Disk Bootstrap Microcode
(Pre-G06.06)
9. Perform firmware updates
required before system load.
TSM Service Application
or OSM Service
Connection Suite (if OSM
is installed)
Section 7, Updating
Service Processor (SP)
Firmware
Section 8, Updating
Processor Boot Code
10. Activate the new software
revision.
DSM/SCM ZPHIRNM
program
Section 10, Running
ZPHIRNM
11. Update EMS template files (if
necessary).
INSTALL^TEMPLATES
TACL macro
If Running
INSTALL^TEMPLATES Is
Required on page A-7
12. Halt the processors. TSM Low-Level Link
Application or OSM Low-
Level Link
Halt the Processors on
page 11-2
13. Load the new operating
system from disk into the
memory of one processor
(system load).
TSM Low-Level Link
Application or OSM Low-
Level Link
Section 11, Loading the
G06.25 RVU
14. Reload the new operating
system into the rest of the
processors.
TACL RELOAD
command
Section 11, Loading the
G06.25 RVU
15. Perform firmware updates
required after system load.
TSM Service Application
or OSM Service
Connection. (Must use
OSM for 6780 switch.)
Section 9, Updating SCSI
Boot Code (Pre-G06.08
RVU)
Section C, Updating SWAN
Concentrator CLIP
Firmware
16. Configure specific optional
products
SCF, macros Configure Specific Products
(Post-System Load) on
page 12-12
Table 1-6. Tasks and Tools for Installing the G06.25 RVU (page 2 of 2)
To Perform This Task... Use This Tool... Documented in...