G06.25 Software Installation and Upgrade Guide

Overview of Installing G06.25

G06.25 Software Installation and Upgrade Guide—529430-001

1-36

Safeguard (G06.25)

Starting with the G06.25 RVU, including the Safeguard software in the OSIMAGE

results in no TACL prompt after a system load. To load the G06.25 RVU, Safeguard

must be removed from the OSIMAGE.

To configure the Safeguard software to run continuously from the time the system is

loaded until the time it is stopped, add the Safeguard software as a persistent process

to the Kernel subsystem. For detailed information on this and other optional Safeguard

installation procedures, see the T9750AER softdoc and the Safeguard Administrator's

Manual, Section 10.

There are considerations for possible fallback to a previous Safeguard T9750 SPR.

Compatibility with previous Safeguard SPRs is maintained. However, if the T9750AER

SPR is installed and the DISKFILE-PATTERN feature is used, you must evaluate if

equivalent non-pattern protection records are required after fallback. See the

T9750AER softdoc for details.

Spooler (G06.00 through G06.19)

If your current product version of spooler is T9101D41 ADM or later, you do not need

to restore copies of both the control file and the collector data files if you must back out

of the new RVU. All versions of T9101D41, starting with T9101D41 ADM, contain

Version 5 of the spooler control file and are compatible with the T9101D46 and D48

product versions of spooler. However, it is always recommended that you back up both

the spooler control file and collector data files before migrating or changing the

configuration.

S78000SE G06.25 S78000 CRUs must be removed. NonStop

S78000 CRUs are supported for G06.16 and

later RVUs only. See the Interactive Upgrade

Guide for details.

S88000 G06.24 S88000 CRUs must be removed. NonStop

S88000 CRUs are supported for G06.24 and

later RVUs only. See the Interactive Upgrade

Guide for details.

S88000SE G06.25 S88000SE CRUs must be removed. NonStop

S88000SE CRUs are supported for G06.24

and later RVUs only. See the Interactive

Upgrade Guide for details.

Table 1-9. Upgrading to NonStop S-Series CRUs and Falling Back (page 2 of 2)

NonStop PMF CRU

Introduced in

this RVU Action