G06.25 Software Installation and Upgrade Guide

Overview of Installing G06.25
G06.25 Software Installation and Upgrade Guide—529430-001
1-43
TNOS Server and TNOS Utility (G06.17)
DELETE TMF command might also be one of the required steps if you alter the audit-
trail format and then find it necessary to fallback.
Refer to the HP NonStop TMF Supplement for Large Audit-Trail Files for details related
to falling back after using these new TMF command options introduced in G06.24.
TNOS Server and TNOS Utility (G06.17)
The TNOS Server (T8666) and the TNOS Utility (T8667), two components of HP
NonStop ODBC/MP, have been updated in G06.17 and later to correct data alignment
problems. To avoid data alignment problems, users of the TNOS Server and TNOS
Utility who are migrating to an RVU before G06.17 must also upgrade their TNOS
Server and TNOS Utility to these new versions:
•
T8666ACL or later (for TNOS Server)
•
T8667ACL or later (for TNOS Utility)
The marketing ID for the new versions is SJ08V1, and the Independent Product (IP)
name is NonStop ODBC Server and Client.
Post installation instructions can be found in the appropriate PVU softdoc. New EMS
templates are required for the T8666D35 PVU.
See Support Note S02075B for details concerning TNOS and data alignment
problems.
Visual Inspect (G06.20)
G06.20 includes the Inspect subsystem (T9226G06) and the Visual Inspect server
(T9756AAH) that support PIC programs and DLLs. This version of the server requires
version 2.4 of the Visual Inspect client (T7877AAD).
If you run client product version 2.3 with a G06.20 or later RVU, the client is connected
automatically to the previous version of the server (T9756AAG), and you will not be
able to debug or analyze snapshot dumps from a PIC process.
Unfortunately, client product version 2.4 is incompatible with earlier versions of the
server. Therefore, it can be difficult to debug from the same workstation on multiple
systems, where some systems run G06.20 or later RVUs and some run earlier RVUs.
There are two ways to approach this problem:
•
Install the newer server on the older NonStop systems, along with a compatible
version of the Inspect subsystem. You can install Visual Inspect server SPR
T9756AAH and Inspect subsystem SPR T9226AAK on an HP NonStop K-series
server running the D45.00 or later RVU, or on a NonStop S-series server running
G05.00 through G06.19 RVUs. See the T9756AAH softdoc.