G06.25 Software Installation and Upgrade Guide

Overview of Installing G06.25
G06.25 Software Installation and Upgrade Guide—529430-001
1-44
WAN Wizard Pro (G06.21 through G06.25)
•
Install both Visual Inspect client product versions 2.3 and 2.4 on the workstation.
However, you cannot run both at the same time, and version 2.3 can encounter
problems after 2.4 has run.
WAN Wizard Pro (G06.21 through G06.25)
The NonStop System Console Installer CD (S7X-SWV1, Update 4) includes the WAN
Wizard Pro client version 4.00. This client version is compatible with G06.21 and later
SUTs only. If you have to fall back to a pre-G06.21 RVU, you must de-install the
previous WAN Wizard Pro and re-install the previous WAN Wizard Pro on your system
console. See the WAN Wizard Pro Support Note S04064 for details.
X25AM
A new SCF line modifier, EMSFORFRMR, is provided so that an EMS message is
displayed when a link reset occurs from a Frame Reject (FRMR) condition on an
X25AM line. The modifier accepts values in the range from 0 to 200. Configure this
SCF modifier with a nonzero value to enable the generation of an EMS message
during an FRMR condition. (By default, the feature is disabled.)
See the X25AM Configuration and Management Manual and the X25AM Management
Programming Manual for more information.
Because there are changes included in T1096 (WANX25LAPB), T0051 (CSSLAPB -
X21DRIVER), and T9323 (X25 SCF-PM) for this new feature, provide the SPR
requisites documented in the T9060AFM (X25AM) softdoc.
Note. Note that the Visual Inspect client is an independent product and must be ordered
separately. HP strongly recommends that you upgrade both the client and server products
at the same time.
See all related softdocs for installation and configuration information.