G06.25 Software Installation and Upgrade Guide

Preparing to Upgrade the Server Software
G06.25 Software Installation and Upgrade Guide—529430-001
4-14
Check the Status of the Spooler Collector
Status of $AUDIT0.ZSYSSWAP.CPU3A
CPU 3
CPU Pages: Total 2048 Reserved 1541 Available 507
Peak CPU Pages ever reserved 1638
Threshold 1740 CPU pages
.
.
Check the Status of the Spooler Collector
Check that the spooler collector is active and not 100 percent full.
At a TACL prompt, start SPOOLCOM and issue a COLLECT, STATUS command. For
example:
1> spoolcom $spls; collect, status
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 44
Check the Tape Drive Status
Check that the tape drive to be used to install the SUT is started and online:
1. At a TACL prompt, enter:
> SCF STATUS TAPE $*
2. Verify that the STATUS TAPE display includes the tape subsystem you plan to use
to load the SUT. For example:
STORAGE - Status TAPE \ELI.$SILO2
LDev State Primary Backup DeviceStatus
PID PID
138 STARTED 0,295 1,279 ONLINE
3. If the tape subsystem you plan to use is not listed, select another tape drive or add
the tape drive to your system configuration. The state of that tape drive must be
STARTED, and the device status must be ONLINE.
4. If the status of the tape drive is stopped or not ready, start the tape drive and put
the tape drive online.