G06.26 Software Installation and Upgrade Guide

Contents
G06.26 Software Installation and Upgrade Guide—529886-002
viii
16. Running ZPHIRNM to Reactivate the Previous
Software Revision
16. Running ZPHIRNM to Reactivate the Previous Software
Revision
Alerts 16-1
Drain the Spooler 16-1
Run ZPHIRNM 16-2
Using PREVIEW Mode 16-2
Run ZPHIRNM 16-2
Verify That ZPHIRNM Ran Successfully 16-3
17. Loading the Previous RVU and Resuming Normal
Operations
Alerts 17-1
Prepare to Stop the System 17-2
Halt the Processors 17-2
Remove Hardware Installed During Migration 17-2
Perform a System Load With the Previous SYSnn and CONFxxyy 17-3
Reload the Remaining Processors 17-3
Resume Normal Operations 17-4
Configure Spooler 17-5
Re-configure DSM/SCM User IDs (If Necessary) 17-5
A. Using DSM/SCM to Install SPRs
Tools for Managing SPRs A-1
Scout for NonStop Servers A-1
DSM/SCM A-2
SPRNOTES A-2
Install SPRs With DSM/SCM
A-2
Save the Current Configuration
A-2
Determine the Current SYSnn A-3
Receive the SPR Into the DSM/SCM Archive A-4
Create a New Software Configuration That Includes the SPR A-5
Build the New Revision A-5
Print Operator Instructions From the Target Interface (ZPHITI) A-6
Run ZPHIRNM A-6
If Running INSTALL^TEMPLATES Is Required A-7
If a System Load Is Required A-9
Halt the Processors A-9
Perform a System Load A-10
Reload the Processors (If Necessary) A-11