G06.26 Software Installation and Upgrade Guide

Installing the G06.26 RVU

G06.26 Software Installation and Upgrade Guide—529886-002

5-13

Build and Apply the New Software Revision

The Build process creates an activation package containing all the products listed in

the new software revision.

To avoid disrupting other system activity, schedule the Build to run at night and the

Apply to run immediately after the Build. See the DSM/SCM User’s Guide for

information about scheduling the Build/Apply to run at different times.

To build and apply the new software revision:

1. In the New software revision dialog box, click Build/Apply to display the options

for your Build/Apply.

It might take several minutes for DSM/SCM to assemble the build information.

During this time, the Build/Apply Request dialog box options and commands are

dimmed and unavailable.

Note. The Activation Package contains installation instructions for the pax files of those OSS

products that contain A7CINFO files in their distributed subvolumes.

Note. You might receive this message:

The message is warning you that the last DSM/SCM snapshot was created by a pre-T6031D46

version of DSM/SCM, which would be the case if you have not installed the T6031D46 product

version. If you are certain that you are on a D46 PVU of DSM/SCM, ignore the message and

continue with the G06.26 installation. If you are unsure of the DSM/SCM product version, log

on to the Target Interface (TI) by running ZPHITI (page 5-18). The current version of TI

appears on the logon screen.

If you know that you have activated the D46 DSM/SCM product version, click OK and continue

with the installation.

If you have previously installed the D46 DSM/SCM PVU and created a snapshot, the error

message does not appear.