G06.26 Software Installation and Upgrade Guide

Updating Processor Boot Code
G06.26 Software Installation and Upgrade Guide—529886-002
8-2
As documented in HS02865, there are at least three strategies for updating processor
boot code firmware, with subsequent methods for reloading the processors. See
HS02865 for further details.
This section combines the three Hotstuff strategies into two major methods:
•
Method 1: Using G06.24 OSM or TSM SPRs, Update Processor Boot Code Using
the Explicit Online Option on page 8-4
To use this method, you must have at least the G06.24 OSM or TSM SPRs
installed on your client and server. In this case, you can select the explicit online
boot code update available in either TSM or OSM. Note that if you are on an
S7000, the online update option does not appear.
It is possible to update OSM and TSM SPRs to the latest versions and still decide,
based on previous adhered-to practices, not to update the processor millicode
using the explicit online option. Follow the steps described in Method 2.
•
Method 2: Using Your Current Pre-G06.24 OSM or TSM SPRs, Update the
Processor Boot Code and Issue a Hard Reset Action or Equivalent on page 8-10
To use this method, you must have down-rev G06.24 OSM or TSM SPRs installed
on your client and server. If this is the case, you cannot use the explicit online boot
code update. It will cause a processor halt.
It is possible to update your OSM and TSM SPRs to the latest versions and still
decide not to update the processor millicode using the explicit online option
available in either TSM or OSM. In this case, you must issue a Hard Reset action
or a Reload during the system load procedure. See Section 11, Loading the
G06.26 RVU.