G06.26 Software Installation and Upgrade Guide

Updating SCSI Boot Code (Pre-G06.08 RVU)
G06.26 Software Installation and Upgrade Guide—529886-002
9-3
Using TSM to Update SCSI Boot Code (If
Necessary)
4. Select all resources that have a current version different from the file version
recorded in SCSI Boot Code Product Numbers on page 9-1, and then click Add to
move selected resources to the Selected box.
If all firmware versions match, you do not need to perform the update for the
selected fabric (X or Y). If you have not yet checked the firmware in the other
fabric, repeat Steps 2 through 6. Otherwise, close the Firmware Update and
Firmware Update Action Summary dialog boxes and resume the upgrade
procedure as described in Section 12, Resuming Normal Operations.
5. Click Perform action.
The update starts, and the Firmware Update Action Summary dialog box appears.
6. Monitor the status of the processor boot code update in the Firmware Update
Action Summary dialog box.
When the action status appears as Completed, the SCSI boot code update is
finished.
7. Repeat Steps 2 through 6 to update the SCSI Boot Code, X-side.
The Firmware Update Action Summary dialog box should confirm that all SCSI
boot code for all PMF CRUs has been updated successfully.
8. Close the Firmware Update and Firmware Update Action Summary dialog boxes.
vst900.vsd