G06.26 Software Installation and Upgrade Guide

Overview of Installing G06.26
G06.26 Software Installation and Upgrade Guide—529886-002
1-8
Updating Firmware
NonStop Cluster Switch Firmware
To monitor and manage a ServerNet Cluster product configured with 6780 switches,
you can use either the OSM Service Connection or SCF commands. See the
ServerNet Cluster 6780 Operations Guide for more information.
For information on required software, installation, migration, and fallback procedures,
see the ServerNet Cluster 6780 Planning and Installation Guide.
ServerNet Adapter Firmware
You can manage firmware in most ServerNet adapters either manually with either OSM
or TSM, or automatically, when the autofirmup attribute is set by SCF (the default when
you add an adapter). If you choose to disable the autofirmup attribute of these
adapters, then you must use the OSM Service Connection or TSM Service Application
to manage the firmware manually based on the information in Table 1-2 on page 1-11.
The ServerNet adapters are:
•
ATM 3 ServerNet adapter (ATM3SA)
•
Ethernet 4-Port ServerNet adapter (E4SA)
•
Fast Ethernet ServerNet adapter (FESA)
•
Gigabit Ethernet ServerNet adapter (GESA-C and GESA-F)
•
Token-Ring ServerNet adapter (TRSA)
•
6763 Common Communication ServerNet adapter (CCSA)
•
Gigabit Ethernet 4-Port adapter (G4SA)
•
Fibre Channel ServerNet adapter (FCSA)
For more information, see the adapters’ respective installation and support guides.
Firmware Updates and DSM/SCM (ZPHITI)
The DSM/SCM Target Interface (ZPHITI) provides operator instructions that inform you
if any firmware needs to be updated before you run the ZPHIRNM (rename) program.
Always check your current firmware versions against the latest on the SUT and on
Scout.
Note. The ServerNet/FX and ServerNet/FX2 adapters do not provide the autofirmup capability.
The firmware for these adapters must be managed manually.
Only OSM supports FCSA (8400) and G4SA (8800).