G06.26 Software Installation and Upgrade Guide

Overview of Installing G06.26
G06.26 Software Installation and Upgrade Guide—529886-002
1-16
Installing a New RVU
9. Perform firmware updates
required before system load.
TSM Service Application
or OSM Service
Connection Suite (if OSM
is installed)
Section 7, Updating
Service Processor (SP)
Firmware
Section 8, Updating
Processor Boot Code
10. Activate the new software
revision.
DSM/SCM ZPHIRNM
program
Section 10, Running
ZPHIRNM
11. Halt the processors. TSM Low-Level Link
Application or OSM Low-
Level Link
Halt the Processors on
page 11-2
12. Load the new operating
system from disk into the
memory of one processor
(system load).
TSM Low-Level Link
Application or OSM Low-
Level Link
Section 11, Loading the
G06.26 RVU
13. Reload the new operating
system into the rest of the
processors.
TACL RELOAD
command
Section 11, Loading the
G06.26 RVU
14. Perform firmware updates
required after system load.
TSM Service Application
or OSM Service
Connection. (Must use
OSM for 6780 switch.)
Section 9, Updating SCSI
Boot Code (Pre-G06.08
RVU)
Section C, Updating SWAN
Concentrator CLIP
Firmware
15. Configure specific optional
products
SCF, macros Configure Specific Products
(Post-System Load) on
page 12-12
Table 1-6. Tasks and Tools for Installing the G06.26 RVU (page 2 of 2)
To Perform This Task... Use This Tool... Documented in...