G06.26 Software Installation and Upgrade Guide

Installing SPRs Before Upgrading to the G06.26

RVU

G06.26 Software Installation and Upgrade Guide—529886-002

3-3

Summary of the SPR Installation Procedure

1. Use Scout to verify that you can apply the DSM/SCM SPR to your current G-series

RVU.

2. Use DSM/SCM to install the required SPRs. For detailed instructions, see

Appendix A, Using DSM/SCM to Install SPRs.

3. Update the firmware or boot code if needed.

4. Use the INSTALL^TEMPLATES macro located in the TACLMACS file to install

EMS template object files from SPRs on a running system if SYSGEN and system

load are not required.

5. Run ZPHIRNM.

6. Perform a system load if SYSGEN is required.

7. Update SWAN and other firmware as needed.

For DSM/SCM D46 and OSM SPRs, different instructions apply.

D46 SPR of DSM/SCM

You must install both the client and server-side T6031D46 product version update

(PVU) to manage OSS files. HP always recommends that you upgrade to the newest

software product revision (SPR) of DSM/SCM. Apply the T6031D46^ABN SPR of

DSM/SCM before receiving the G06.26 SUT.

After you activate the T6031D46^ABN or later server software, the ZDSMEXE file will

be available to download from the ZDSMSCM subvolume so that you can update the

client. (You do not need to update the DSM/SCM client to the D46 server side

immediately to receive the G06.26 RVU successfully.) However, HP recommends that,

for your production environment, both the client and server side of DSM/SCM PVUs

match.

Appendix B, Installing the Latest DSM/SCM SPRs and Client Software contains

instructions for installing a D46 SPR of DSM/SCM, including the client.

Determining Your Current DSM/SCM Version

To verify which version of DSM/SCM is currently installed on your system, use the

VPROC command to determine the product version of TAEXE (Apply product of

DSM/SCM) and CBEXE (Build product of DSM/SCM). At a TACL prompt, enter:

> volume $dsmscm_vol.ZDSMSCM

> vproc taexe

> vproc cbexe

Caution. You must install the D46 client version of DSM/SCM to activate DSM/SCM

management of OSS files for a target.