G06.27 Software Installation and Upgrade Guide

Contents

G06.27 Software Installation and Upgrade Guide—540067-001

A. Using DSM/SCM to Install SPRs (continued)

If Running INSTALL^TEMPLATES Is Required A-7

If a System Load Is Required A-9

Halt the Processors A-9

Perform a System Load A-10

Reload the Processors (If Necessary) A-11

Start Your Applications and Processes A-11

B. Installing the Latest DSM/SCM SPRs and Client Software

Before You Begin Installing the Software Identification (SWID) and DSM/SCM

SPRs B-3

Alerts B-3

Determine the Product Version of DSM/SCM on the Host System B-3

Determine the Product Version of DSM/SCM on the Client B-4

Copy (RESTORE) the T6031G02 DSM/SCM Product Version and SWID to Disk B-5

Receive the G02 SPRs for DSM/SCM B-5

Create a New Software Revision for DSM/SCM G02 SPR and G02 SWID B-8

Build and Apply the DSM/SCM G02 Software Revision B-9

Rename the Applied DSM/SCM G02 Files B-11

Run the INSTALL^TEMPLATES Macro B-11

Restart Applications B-12

Before Starting DSM/SCM B-12

Start DSM/SCM B-12

Verify That the Newest Product Version of DSM/SCM Is Installed B-13

Verify That SWID Is Installed B-13

Recovery for Problems While Installing the G02 PVU of DSM/SCM B-14

If NonStop Errors Are Displayed

B-14

Install the DSM/SCM Client From ZDSMSCM

B-14

Alert (DSM/SCM T6031G02 Client) B-14

Determine Your DSM/SCM Client Software Version B-15

Determine the Current IP Address and Port Number B-15

Copy the ZDSMSCM Client File From the Host B-16

Install the DSM/SCM Client Software B-17

Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR)

Disk B-21

C. Updating SWAN Concentrator CLIP Firmware

Using the SWAN Fast Firmware Update Guided Procedure C-2

If the SWAN Fast Firmware Update Fails C-7

Using the TSM Firmware Update Dialog Box to Update SWAN Firmware C-8