G06.27 Software Installation and Upgrade Guide

Installing the Latest DSM/SCM SPRs and Client

Software

G06.27 Software Installation and Upgrade Guide—540067-001

B-11

Rename the Applied DSM/SCM G02 Files

1. Stop DSM/SCM:

> VOLUME $dsmscm_vol.ZDSMSCM

> RUN STOPSCM

where $dsmscm_vol is the DSM/SCM volume.

2. Run ZPHIRNM:

> RUN ZPHIRNM $volume.SYSnn

where SYSnn is the current SYSnn (because no SYSGEN or system load is

required).

3. When asked if you want to use a log file with the session, enter Y.

4. When prompted, enter a file name for the log file.

ZPHIRNM displays this message:

Log file, filename, was successfully created.

ZPHIRNM processes the file renaming.

5. Verify that ZPHIRNM ran successfully by reviewing the specified log file.

Run the INSTALL^TEMPLATES Macro

EMS templates are used by EMS to format EMS messages. After running ZPHIRNM,

and if notified to do so by DSM/SCM, run the INSTALL^TEMPLATES TACL macro to

install DSM/SCM EMS templates in their proper locations.

The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume

and invokes the TEMPLI program to build new resident and nonresident EMS template

files.

You must be logged on as the super ID (255, 255) to run the INSTALL^TEMPLATES

macro. This macro cannot be run with the NOWAIT option and takes approximately ten

minutes to finish.

For detailed instructions on running the INSTALL^TEMPLATES macro, including

troubleshooting information, see If Running INSTALL^TEMPLATES Is Required on

page A-7.

Note. The files newres and newnres are used as temporary names until the next SYSGEN

and system load.